Invacare FDX, Руководство пользователя, Страница: 55 / 120

Setup
6. Pull or push the seat support plate (2) the required
width. A scale (3) has been fitted to the bottom part
of the seat support. Use this scale to read off the seat
width in centimeters.
7. Repeat these operations on the other side of the seat.
8. Now tighten all the screws again.
5.14.2 Adjusting the seat depth
Also refer to the previous chapter entitled 5.14.1
Adjusting seat width, page 54 .
The seat depth can be adjusted in stages between
380 and 530 mm.
Tools:
• 4 mm Allen key
• 8 mm jaw spanner
• oblique pliers
• cable binder
Particular holes in the seat support must be used to
the screws depending on the required seat depth. It
may also be necessary to replace the seat support
plate.
1. Please use the following figures and the table to
determine which holes need to be used for the required
seat depth, and therefore whether the seat support
plate needs to be replaced or not.
Seat
depth
in cm
Holes used
in front seat
frame order
no.: 1524550 Holes used
in rear seat
frame order
no.: 1524555 Seat
support
plate
required
38 6 & 7 A & B
41
5 & 7 A & C
43 4 & 6 A & C
SHORT
order no.
1526437
43 4 & 6 A & C
46 3 & 5 A & C
48 2 & 4 A & C
MEDIUM
order no.
1526438
48
2 & 4 A & C
51 1 & 3 A & C
53 1 & 2 B & C
LONG
order no.
1526439
2. Adjust the seat depth as described in the following
chapter:
- If the seat support plate does not need to be replaced,
please refer to chapter
5.14.3 Adjusting the seat depth
without replacing the seat support plate, page 56 .
1541361-N 55