Service
4.
Loosen and remove screw
A
that attaches swing arm to
chassis on left and right side of the mobility device.
5.
Loosen and remove lower bolt
B
on rear shock absorber
on left and right side of mobility device.
Be careful not to loose metal bushing
A
in swing
arm
B
.
6.
Remove and replace swing arm.
7.
Install parts in reverse order.
When reinstalling, tighten screw
A
to 15 Nm.
4.8.4 Replacing steering column
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
•
10 mm wrench
•
13 mm wrench
•
17 mm wrench
•
19 mm wrench
•
32 mm wrench
•
Phillips screwdriver
•
Supporting wooden block
1.
Remove seat.
2.
Remove shroud.
3.
Disconnect battery cable.
4.
Place a supporting wooden block under the front part of
the frame so that the front wheel is no longer touching
the floor.
1603798-B
23
