Invacare Action3 NG, Руководство по обслуживанию

Страница: 9 / 20

60122664-A 9
2.4 Adjusting Wheelbase Length
NOTE: For this procedure, refer to FIGURE 2.1 to section 2.1 Removing/Installing Central Wheels.
1. Remove the wheel. Refer to section 2.1 Removing/Installing Central Wheels paragraph.
2. Remove the four mounting screws A that secure the top and bottom of the adjustable
axle bracket
B
to the back-cane bracket
C
.
3. Align the adjustable axle bracket
B
with the adjustment holes on the back-cane bracket
C
. There are 3 positions possible: Factory setting is position “A” Standard, position “B”
is more Passive (better stability), position “C” is more Active (better manoeuvrability).
NOTE: For this procedure, refer to FIGURE 2.4.
4. Secure the adjustable axle bracket to the back-cane bracket, at the desired length, with
the locknut and washer
D
.
5. Repeat STEPS 1 to 4 for the other axle bracket.
NOTE: Both adjustable axle brackets should be set at the same position.
WARNING
The four mounting screws need to be four adjustment holes apart to maintain frame
integrity.
Active position “C” and Passive position” B” (not factory settings) of the axle plates directly
relate to the stability of the wheelchair. Any change to one or any combination of the 3
positions may cause the wheelchair to increase/decrease in stability.
FIGURE 2.4
Position “C” Active Position “A” Standard Position “B” Passive
C
D
D
A
B