Invacare Action3 NG, Руководство по обслуживанию

Страница: 4 / 20

Invacare
®
Action3 NG RC
4
1.2 Tightening Torques
The tightening torques stated in the following table are dependent on the thread diameters for
the nuts and bolts for which no special values are determined. All values apply to dry and
grease-free threads.
Thread M4 M5 M6 M8 M10/12
Tightening torque
in Nm mini/max.
1,5/3 Nm 3/6 Nm 7/12 Nm 10/20 Nm 20/30 Nm
1.3 Suggested Maintenance Procedures
1. Before using your wheelchair, make sure all nuts and bolts are tight. Check all parts for
damage or wear and replace if necessary. Check all parts for proper adjustment.
2. Keep quick release axles free of dirt and lint to ensure positive locking and proper
operation.
3. Clean quick release axles once a week with a Teflon lubricant.
4. Recommended tire pressure is listed on the sidewall of the tire (BAR, KPa or P.S.I.).
5. The wheels, castors and tires must be checked periodically for cracks and wear and must
be replaced when necessary.
6. Regularly check for loose spokes in the rear wheels. If loose, have them adjusted.
7. Periodically check handrims to ensure they are secured to the rear wheels.
CAUTION
All other nuts not noted here must be tightened FINGERTIGHT!
WARNING
DO NOT use WD-40, 3-in- 1 oil, or other penetrating lubricants on quick-release axles.
Otherwise, binding and/or damage to the wheelchair may occur.
WARNING
DO NOT use your wheelchair unless it has the proper tire pressure (BAR, KPa or P.S.I.).
DO NOT over inflate the tires. Failure to follow these suggestions may cause the tire to
explode and cause bodily harm. The recommended tire pressure is on the sidewall of the
tire.
CAUTION
As with any vehicle, the wheels and tires must be checked periodically for cracks and wear
and must be replaced if damaged.