Invacare Action3 NG, Руководство по обслуживанию

Страница: 16 / 20

Invacare
®
Action3 NG RC
16
5.2 Inspect/Adjust Weekly

Wheelchair rolls straight (no excessive drag or pull to one side).

Quick-release axles lock properly (see page 8).
 Inspect for broken spokes.

Wheel/fork assembly has proper tension when castor is spun. Castor should come to a
gradual stop.

Inspect tires/castors for flat spots and wear.
 Check pneumatic tires for proper inflation
(recommended tire pressure is listed on the side wall of the tire).
 Ensure castors are free of debris.
5.3 Inspect/Adjust Monthly
 Inspect seat positioning strap for any signs of wear. Ensure buckle latches. Verify hardware
that attaches strap to frame is secure and undamaged. Replace if necessary.

Loosen/tighten locknut if wheel wobbles noticeably or binds to a stop.
 Wheel bearings are clean and free of moisture.

Wheel brakes do not interfere with tires when rolling.
 Wheel brake pivot point are free of wear and looseness.

Check the tension and appearance of the brake cable.
 Ensure all castor/wheel/fork/head tube fasteners are secure (see pages 4 & 11).

Ensure all hardware is tight (see page 4).
 Ensure hand grips are secure to backrest canes.

Ensure castors are free of debris.
5.4 Inspect/Adjust Annually (1)
 Wheelchair rolls straight (no excessive drag or pull to one side).

Adjustable height arms operate and lock securely.
 Armrest armpad sits flush against arm tube.

All fasteners on clothing guards are secure.
 Seat and/or back upholstery have no rips.

Inspect adjustable angle back attaching hardware is securely tightened.
 No excessive side movement or binding when rear wheels are lifted and spun.

Inspect handrims for signs of rough edges or peeling finish.
 Inspect tires/castors for flat spots and wear.

Check pneumatic tires for proper inflation
(recommended tire pressure is listed on the side wall of the tire).

Wheel brake pivot point are free of wear and looseness.
 Clean upholstery and armrests.
 Sealed bearings and axle nut tension are correct.

Wheel/fork assembly has proper tension when castor is spun. Castor should come to a
gradual stop.

Loosen/tighten locknut if wheel wobbles noticeably or binds to a stop.
 Wheel bearings are clean and free of moisture.