Invacare 1521677, Руководство пользователя

Страница: 18 / 24

Dolomite Step Up®
Sound level 48 dB(A)
Type B Applied part Applied Part complying with the specified requirements for protection against
electrical shock according to IEC 60601-1. (An applied parts is a part of the
medical equipment which is designed to come into physical contact with the
patient or parts that are likely to be brought into contact with the patient.)
*IPX4 classification means that the electrical system is protected against water splashed at the component from any direction.
The IP-classification of the hand control decides the overall classification of the product.
8.3 Material
Frame
Polyester powder coated aluminium
Handle bars Anodised aluminium
Handgrips Foam rubber, TPE (no known allergic
reactions)* / PVC**
Arm pads Dartex (no known allergic reactions)
Wheels Polyamide with rims of polypropylene
and treads of TPE
Plastic parts Material according to marking (PA, PP, PE)
Screws
Steel, rust protected
* For models 1521677, 1521678, 1536121, 1521679,
1536122, 1579540
** For models 1585401, 1587608, 1587609
8.4 Environmental conditions
WARNING!
Step Up Electric may only be used in wet areas
when it runs on battery.
– Do not use Step Up Electric in wet areas while
it is connected to the mains.
– Make sure the walking table is dry before
connection it to the mains.
Operation Storage Transportation
Temperature +5°C to +40°C
-10°C to
+50°C
-10°C to
+50°C
Relative
humidity
20% to 100% 20% to 75% 20% to 75%
Atmospheric
pressure
700 hPa to 1060 hPa
The walking table may be used in wet areas, but not under
pouring water (e.g. shower).
8.5 Electromagnetic compliance (EMC)
General information
Products with electronic equipment needs to be installed and used according to the EMC information in this user manual.
WARNING!
Portable and mobile communications equipment can affect the operation of this product.
This product must not move unintentionally while being submitted to Electromagnetic interference
– If this should happen; the product must immediately be taken out of use and checked by a qualified technician.
This product has been tested and complies with the EMC limits specified by IEC 60601-1-2 for Class B equipment.
This product has a very low emission and should not interfere with other equipment.
However, if other devices nearby should react inexplicably, run and stop this product and observe the devices.
• If nothing happens with the other devices, then this product is not causing the error.
• If other devices are behaving in an inexplicable manner, then this product is causing the error. Solve the problem
by moving or increasing the distance between them.
18 1532567-G