6
Installation of UCI-11C Video Interface
Installation of the Prodigy 1.2 Brain
1. Find a suitable place to mount the navigation brain.
2. Plug in the 24 pin Connector 1 (Labeled “Con 1”) to the Prodigy 1.2 brain.
3. Connect the RGB and Data cables coming from the UCI-11C into the RGB and Data cables on
the Connector 1 harness. NOTE: These plugs do not have locking tabs. It’s suggested that you
heat shrink over the connection once made, or at least wrap tightly with electrical tape
4. Make all of your power connections. Red – ACC, Black – GND, Yellow – CO12v.
You will not use the White wire, simply insulate it to avoid any accidental contact. These
power connections must be made at the cigarette lighter power wires. DO NOT make power
connections behind the radio or tap into the NAV-TV T-harness. The UCI-11C is very sensitive
to current draw and will shut down if you tap into a circuit it is using. On most applications, the
cigarette lighter wires are very easy to get to.
5. 5. Run your antenna, speaker, and microphone. Please reference the connector diagram on
page 5.
6. Once all connections are made, start system and begin the setup process.
1. Remove the factory dash of vehicle to gain access to
the radio head. Pull the radio out enough to gain access
to the wiring on the back. Unplug the factory white 22
pin connector from behind the radio. Install the male
end of the supplied NAV-TV T-harness into the radio head.
Plug the factory 22 pin connector into the female end of
the supplied T-harness.
2. Route the free end of the T-harness behind the radio and
up behind the factory screen.
3. When you removed the dash, there would have been a
white round LVDS connector plugged into the back of
the dash/monitor assembly. Take this connector and
insert into the white UCI-11C port labeled “Radio.” Take
the provided NAV-TV LVDS cable and insert the black end
into the UCI-11C port labeled “screen.”
4.
At this point you should find a suitable place to mount the
UCI-11C.
5. Plug the free end of the supplied NAV-TV T-Harness (18
pin) into the UCI-11C port labeled “radio.”
6. Plug the supplied LVDS cable that you previously inserted
into the black LVDS port on the UCI-11C labeled “screen,”
and plug it into the vehicles factory LVDS port behind the
monitor.
7. If you are using an aftermarket backup camera, plug in the 8 pin Molex plug with the RCA’s
into the UCI-11C. NOTE: ONLY VIDEO 2 WILL WORK AS A BACKUP CAMERA INPUT. The other
inputs are currently non-functional.
8. Locate the Intraphex RGB / Data harness. Plug the 24 pin end into the UCI-11C’s port labeled
“Navigation.”
9. Run the RGB / Data cable to where you will be mounting the Prodigy brain.
