Intplus FlexWATCH 1110, Руководство пользователя

Страница: 34 / 218

Network Camera Server User’s Manual
Seyeon Tech Co., Ltd
34
bash# netconfig
--------------------- Network(LAN) Setup ---------------------
Current configuation
IP Address : 10.20.30.40
Network Mask : 255.255.255.0
Gateway : 10.10.1.1
Enter IP Address :
9) Input new IP address, Network Mask and Gateway values to be assigned to
FlexWATCH
TM
server. After this, press “y” to apply the new network configuration.
Enter IP Address : 10.10.213.22
Enter Network Mask : 255.255.0.0
Enter Gateway : 10.10.1.1
Entered network configuation
IP Address : 10.10.213.22
Network Mask : 255.255.0.0
Gateway : 10.10.1.1.
Do you wish to apply your new network configuration ?
(y/n/q):
y
10) If following messages come up on your screen with “bash# ” prompt, the new
network configuration has successfully applied.
Your network configuration was changed.
Shutting down interface eth0 [ OK ]
Shutting down interface ppp1 [ OK ]
Shutting down interface ppp2 [ OK ]
Setting network parameters [ OK ]
Bringing up interface lo [ OK ]
Bringing up interface eth0 eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
[ OK ]
Bringing up interface ppp1 [ OK ]
Your new network configuration was applied.
bash#
11)
To check whether your Network configuration is correctly applied or not, press
‘ifconfig’ command after “bash#” prompt and then following messages will show up.
On the second line of the ‘eth0’ message, you can check the assigned IP and Mask
values. Gateway value is not seen here. If the values are different from what you want
to set-up, try again the Network configuration from step 8).
- INTPLUS [2005] -