Mechanical installation
INTORQ | BA 14.0214 | 10/2019
24
5
Mechanical installation
This chapter provides step-by-step instructions for the installation.
Important notes
NOTICE
The toothed hub and screws must not be lubricated with grease or oil.
5.1
Design of end shield and shaft
¾
Comply with the specified minimum requirements regarding the end shield and the shaft to ensure a
correct function of the brake.
¾
The diameter of the shaft shoulder must not be greater than the tooth root diameter of the hub.
¾
The form and position tolerances apply only to the materials mentioned. Consult with INTORQ before
using other materials; INTORQ's written confirmation is required for such usage.
¾
The brake flange must be supported by the end shield across the full surface.
¾
Keep the end shield free from grease or oil.
Minimum requirements of the end shield
Size
Material
Roughness
Run-out
Levelness
[mm]
[mm]
17R … 28R
S235JR;
C15;
EN-GJL-250
Rz10 … Rz16
< 0.1
< 0.1
Tab. 5:
End shield as counter friction surface
