INTORQ BFK455-25, Перевод оригинальной инструкции по эксплуатации

Страница: 35 / 50

Mechanical installation
INTORQ | BA 14.0215 | 07/2019 35
Fig. 20: Hand-release at the motor
A
Self-locking nut
B
Clip
C
Tension rod
D
Second complete stator
E
First complete stator
F
End shield
7. Screw four lock nuts between the motor end shield and the complete stator onto the tension rods up
to the point where the back side of the lock nut aligns with the top of the tension rod.
8. Evenly tighten the brake with the six socket head cap screws included in the scope of supply in sev-
eral runs using a torque wrench.
9. Establish the electrical connection and energize the brake (siehe Chapter Electrical installa-
tion, Page 37).
10. Use a torque wrench to re-tighten the supplied fastening screws with the required tightening torque
(Rated data: screw kit for brake assembly onto flange, Page 15).
11. Switch off the power.