93901 5 01/18
GB
175 hybrid
17
4 .3 Motor protection
Should the motor be overloaded it switches off. The
control display (fig. 3/3) comes on. The machine can
be started again after a cooling down period of about
15 – 20 minutes (depending on the model and the
room temperature).
4 .4 Electrical fault
If the function button (fig. 3/1) LED display flashes or
only the control display (fig. 3/7) flashes there is an
electrical fault.
1 .
Switch off the machine once.
2 .
Turn the machine on again.
¾
This helps in many cases.
If the machine still fails to start up, please notify your
dealer.
4 .5 Fault check list
Should the machine not work, check the following
points:
• is the plug connected to the power supply?
• is the door closed?
• is the receptacle full?
¾
Follow the instructions under
„Emptying the CD
receptacle“, p. 15
or
„Emptying the paper recep-
tacle“, p. 15.
• Is there a material jam in the machine?
¾
Follow the instructions in
„Material jam in the
machine“, p. 16
.
• Is the motor overloaded?
¾
See
„Motor protection“, p. 17
.
NOTE!
In many cases, restarting the machine helps:
1 .
Switch off the machine once.
2 .
Turn the machine on again
.
If none of these test points apply, please contact your
dealer.
5 Maintenance / Disposing
5 .1 To change the oil container
Cross-cut cutting mechanisms must be oiled regularly
after a certain period of operation. This is done auto-
matically by the integrated oiler.
If the control display
(fig. 3/8) flashes, this means that
the oil container (fig. 6/3) is empty and must be repla-
ced with a full container. The motor switches off.
NOTE!
To complete the shredding process when the
motor is switched off, press and hold the for-
ward button (fig. 3/2).
¾
The cutting mechanism continues to
run forward for approx. four seconds.
This process can only be activated once.
Changing the oil container:
1 .
Open the door.
¾
The control display (fig. 3/7) comes on.
¾
The control display for the reverse button
(fig. 3/6) flashes.
1
3
2
000080
1
Oil hose
2
Cap
3
Oil container
fig. 6 Oil container
2 .
Change the oil container (fig. 6/3). To do this, un-
screw the cap (fig. 6/2).
3 .
Press the reverse button (fig. 3/6).
¾
The control display (fig. 3/6) goes out.
4 .
Close the door.
¾
The control display (fig. 3/7) goes out.
¾
The control display (fig. 3/8) goes out.
The machine is ready for use again. Should you need
to re-order the special oil see
„Accessories“, p. 18
.
