120
IO
SAVE THESE INSTRUCTIONS
Page 14
(120IO) SEQUOIA SPIRIT™ WOOD-GRAIN FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 08/08/2009
English
S
E
T
U
P
I
N
S
T
R
U
C
T
IO
N
S
POOL SETUP (continued)
You may have purchased this pool with the Intex Krystal Clear™ filter pump.
The pump has its own separate set of installation instructions. First
assemble your pool unit and then set up the filter pump.
1.
• Open the carton containing the liner, joints, legs, etc., very carefully as this carton can be
used to store the pool during the winter months.
• Take out the ground cloth
(11)
and spread
it over the cleared area. Then take out the
liner
(8)
and spread it out over the ground
cloth, with the drain valve directed towards
the draining area. Place the drain valve
away from the house. Allow the sun to
warm up the liner before inserting the
beams
(7)
into the sleeve openings.
IMPORTANT: Always set up the pool
unit with at least 2 persons. Do not drag the liner across the ground as this can
cause leaks or other damages (see drawing 4).
• During the setup of the pool liner, point the hose connections or openings in the
direction of the electrical power source. The outer edge of the pool should be within
reach of the pump’s electrical connection.
2
. • The frame pool’s legs
(5)
and beams
(7)
fall into two groups. The larger diameters are
the horizontal beams that are slid (pushed) into the sleeve openings at the top of the
liner. The smaller diameters are the vertical legs. Both these legs and beams fit into the
T-joints
(3)
.
• Starting at any location, but always working in the
same direction, push the horizontal beam into the
sleeve. Once the beam is centered take one of the
T- joints and using the connection pin
(1)
, attach the
joint to one end of the beam by inserting the pin
through the seal
(2)
and in the pre-drilled holes.
Repeat this procedure in a circular fashion until all
the beams and joints have been connected
(see drawing 5.1)
.
The last joint connection may be difficult to
complete. You can do it though, if you first
simultaneously raisethe last joint and beam about 2
inches (5 cm). Now, insert the beam into the joint while
lowering the pieces into position. The beam will easily
slide into the joint (see drawing 5.2). Ensure that the
last joint is fully connected before proceeding to
assemble the legs.
8
4
1
2
7
3
5.1
5.2
3
