background image

www.intertec.info

Operating Instructions CP MICROTHERM DENA

HOM180473483Ien-3

Page 7 / 7

INTERTEC-Hess GmbH · Raffineriestr. 8 · 93333 Neustadt/Donau · Germany · 

 +49 9445 9532-0 ·   [email protected]

• Sort other components according to their material

properties and dispose of them.

NOTICE

Environmental damage may be caused if dis-
posed of incorrectly!

Electrical scrap and electronics components are subject
to hazardous waste treatment and must only be dis-
posed of by certified specialists!

The  local  community  authorities  or  specialist  waste  dis-
posal  companies  can  provide  information  on  environ-
mentally friendly disposal.

14

Declaration of Conformity

The  manufacturer,  INTERTEC-Hess  GmbH,  Raffiner-
iestrasse  8,  93333  Neustadt/Donau,  Germany,  hereby
declares in sole responsibility that the product

Product / Type designation:

CP MICROTHERM

complies  with  the  provisions  of  the  following  directives
Ministry of Employment and Labor No. 2016-54 complies
with  the  following  standards,  harmonized  standards,
where appropriate and/or standardized documents:

Ministry of Employment and Labor, appendix 6 of notific-
ation 2016-54

Ministry of Employment and Labor, appendix 7 of notific-
ation 2016-54

Ministry of Employment and Labor, appendix 15 of noti-
fication 2016-54

KS C IEC 61000-6-4:2014

KS C IEC 60529

Marking:

18-KA4BO-0090X

18-KA4BO-0089X

Ex d IIC T6...T3

Ex tb IIIC T85°C, T100°C, T135°C, T200°C

Neustadt, May 14th, 2018

Dipl.-Ing. Martin Hess, Managing Director

15

Further information and service

If  the  information  contained  in  this  instruction  manual
should  not  be  sufficient  in  any  way,  then  INTERTEC
would be glad to be at your disposal to provide further in-
formation and service.

Please  contact  your  INTERTEC  contact  person  or  dir-
ectly contact

INTERTEC-Hess GmbH

Raffineriestr. 8

93333 Neustadt/Donau

Germany

Phone: +49 9445 9532-0

e-mail: [email protected]

Website: www.intertec.info

Warranty

The  legally  defined  warranties  and  warranty  periods  of
24 months are applicable to our scope of supply and ser-
vices.

You  will  find  more  detailed  information  in  the  manufac-
turer warranty from INTERTEC for heating systems and
accessories.

These instructions do not claim to take all

designs, options or changes into consid-

eration, even in association with installa-

tion, operation or maintenance. INTER-

TEC does not accept responsibility for

providing information about changes

made retrospectively.

Содержание CP MICROTHERM DENA








Отзывы: