INTERSPORT ENERGETICS POWER RUN 20.1, Руководство пользователя

Страница: 30 / 64

30
Grounding Guide:
This product must be grounded. If the treadmill fails or is damaged, the ground wire can form a minimum resistance circuit, the current
into the ground, thereby reducing the risk of electric shock. This product is equipped with a cable that has a conductor to ground the unit
and a grounding plug. This plug must be plugged into a socket that complies with local codes and regulations for installation and
grounding requirements.
Danger! Improper connection of the equipment grounding conductor may result in an electric shock hazard. If you do not know if the
equipment is properly grounded, consult a service person. Do not change the plug that comes with this product. If the plug does not
conform to the socket, allow a qualified electrician to install a suitable outlet.
This product uses a 220 -240 volts line and is equipped with a grounded outlet as shown in the illustrations below.
Treadmill use instruction
1. Power on, the treadmill will start to the lowest position, check the machine is normal.
2. Attach the safety lock clip to the skirt of the sportsman's chest.
3. Before running, must confirm the stability of the treadmill and function is normal. It is strictly prohibited to stand on the run belt start,
should stand on the side bar, handle bar, once confirm everything well then start running. When power on, put one hand to seize the
handlebars, press the "STAR " button, treadmill delay start 5 seconds to 1.0km / h speed. Press the "speed" "+" key, the motor
speeds up to 2.5 ~ 3.5km / h (this is a most suitable running speed), both hands grab handlebars, feet have to step on the running
belt, can run with the same speed.
4. After a few minutes, you can speed up the running, the growth rate of the requirements is holding hands with the handlebars, press
the "speed" - "" key to run slowly.
5. During the running time, press the speed shortcut keys, you can quickly enter the running speed you need.
6. Press "Stop" key to stop the motor at any time during running.
7. Preset mode: Press the "Select" button to select one of the automatic operation modes as the current running mode. Press the
"Start" key to start the treadmill. The treadmill starts to run automatically according to the selection mode. In operation, you can press
the "speed" + "" key or "speed" - "" key to change the current time period running speed. Press "Stop" to stop the motion.
Note : When safety key pull out ,the treadmill will stop immediately .
And the console can not work ,the window shows “E-07”