120-00011 Rev. New
Halimeter
PLUS User Manual
7/15/2020
7
2.4 ANALOG OUTPUT CONNECTIONS
The Halimeter
PLUS is equipped with 0-2.5 V and 4-20 mA output signals available at
the 10 pin rear panel terminal block as shown below. Each signal range corresponds to the
full scale range of the instrument from 0 - max range.
Connect to the terminal block by inserting wire conductor into the desired terminal and
tightening the terminal’s screw. The terminal block can be removed from the rear panel for
ease of wiring by gently pulling the block away from the panel. Re-connect the block by
gently pressing it back into the receptacle.
Use the VCC output (Pin 3) as the positive reference for the 4-20 mA output (AOUT1
– Pin
8) and the device ground (Pin 1 or 2) as the negative reference for the 2.5 V output (AOUT2
– Pin 7).
PIN
NAME
TYPE
DESCRIPTION
1
2
3
4
5
6
7
8
9
10
GND
GND
VCC
-
-
-
AOUT2
AOUT1
-
-
Reference
Reference
Reference
N/C
N/C
N/C
Analog Voltage Output
Analog Current Output
N/C
N/C
Local Device Ground
Local Device Ground
+5 Volts
-
-
-
Breath Measurement in volts
Breath Measurement in milliamps
-
-
