Interphase Sonar Engine SE-200, Руководство по эксплуатации

Страница: 30 / 40

30
Note: The Forward Horizontal Transducer must be able
to scan beneath the hull. The deadrise angle of the hull
must be less than 10 degrees in order for the forward
horizontal scan to sweep beneath the hull. Alternately,
the transducer can be mounted at or below the lowest
point on the hull.
The transducer can be installed on either side of an
outboard or inboard/outboard engine, or between twin
outboards. For single engine installations, normally 18”
to 24” outboard of the propeller center line is acceptable
and the down stroke side of the propeller is preferred.
Choose a location where water flow is smoothest. For
dual engine installation, just off the center line is usually
acceptable.
Because the transducer rotates back and upwards when
the bracket releases, it must be mounted in a location
where there is sufficient clearance and headroom to allow
the full release.
Attach the Transducer & Spray Shield to the Bracket
Locate the Stainless Spray Shield inside the transducer’s
stainless mounting ears. Make sure the spray shield is
orientated as shown in sketch below. Then, assemble the
stainless kick-up bracket to the transducers using the 4
screws, washers and lock nuts provided. Place the rubber
grommet around the transducer cable and slide it into the
slot in the spray shield. The bracket arms must be
mounted outside the stainless steel mounting ears of the
transducer. Do not fully tighten the lock nuts at this time.
Tighten them after the transducer is mounted and the
spray shield is positioned.
Position the transducer so that it is perpendicular from
side to side and make sure the wider blunt end is pointed
towards the front of the boat.
Mounting the Transducer to the Boat
After you have selected the optimum mounting location
and have assembled the mounting bracket to the
transducer, mount the bracket onto the hull as shown on
the right.
Make sure to position the transducer so that it is level in
the fore and aft direction and so it will look straight
down. Check the location of your boat’s waterline and
position the flat top surface of the transducer so that it is
parallel to the waterline as shown below.
Note: If the transducer is not mounted so that its fore
and aft direction is parallel to the surface, then the
forward looking display will be distorted and flat bottoms
Waterline
Rear
View
Spray Shield
Transducer must be
mounted vertically
Fasten Spray Shield
with 4 screws & nylok
washers as shown
Bracket
Axle
Rubber
Grommet
Side
View
Boat Hull
Mounting
Bracket
Waterline
Fasten Spray Shield
with 4 screws & nylok
Spray
Shield
18 - 24"
Cables
Twin Outboards
Transducers
Cables
Transom Mount Locations