Interpack CE-12P, Руководство по эксплуатации и список запасных частей

Страница: 7 / 43

CE-12P Manual 7
USM8131
5 OPERATING INSTRUCTIONS
The automate vertical CE-12P Case Erector with powered hopper is suitable for
processing a wide range of RSC (Regular Slotted Container) style case sizes without
intervention of an operator to form and bottom seal cases. Its use of pneumatics allows
the machine to extract a single case using 4 or 6 vacuum cups and to fold all four
bottom flaps and seal the bottom center seam with pressure sensitive carton sealing
tape. This section will describe the various components and feature of your Case
Erector.
Once the CE12P is properly installed with the hopper setup and loaded with boxes the
machine is ready for operation (see section 5.6 for set-up procedure). The CE12P has
two operating modes: automatic and manual. The operator selects these modes by
using a 2-position selector switch located on the main control panel of the machine
(Figure 5.2). The CE-12P has installed standard two emergency stops and a control box
for the rise and descent of the powered hopper table.
5.1 Automatic Mode
This is the standard operating mode of the machine. In the automatic mode the machine
will dispense formed and bottom sealed cases when there are no detected cases on the
exit side of the machine. In this mode your CE-12P machine will operate without
operator assistance and warn you if it is out of cartons and tape or if low of tape. The
CE12-P machine has two options when automatic mode is selected: single cycle and
continuous cycle.
5.2 Manual Mode
The manual mode is used for as a troubleshooting tool and for setting up the machine
when changing over to a different case size; see section 5.6 for properly setting up your
CE-12P Case Erector machine.
In this mode your CE-12P machine is capable of single stepping through to complete
one cycle for easy and fast set-up for changing over different case sizes.
Note: When “Power On,” “Manual Reset” buttons are lit solid, and “Single Cycle”,
“Continuous Cycle,” “Stop Cycle” buttons are flashing the machine is in automatic
mode and is an indication that is ready to operate either single cycle or continuous
cycle motion.