Interpack CE-12P, Руководство по эксплуатации и список запасных частей

Страница: 10 / 43

CE-12P Manual 10
USM8131
5.6 Set-up
The set-up process for your CE-12P is simple and does not require any tools or
changeover parts to accomplish. The Case Erector is fitted with hand wheels for ease of
moving side belts, and upper table to conform to your desired size of cases. Also, it has
a powered hopper with an Up-Down control buttons to make adjustments effortlessly.
For the initial set-up of your CE-12P for a particular size of case the Case Erector
should be in manual mode and tape roll loaded. Follow the preceding steps below to
set-up your CE-12P machine.
1. Obtain a box or case sample you need to process and fold the bottom minor and
major flaps of the selected case to set-up the machine. Figure 5.4 shows an
example of a bottom folded case.
2. Put the box with the bottom flaps
folded under the exit side of the
machine (side belts) make sure your
side belts are wide enough and the
upper table high enough to fit the case
(Figure 5.5).
3. Lower the upper table until
approximately ¼” inch of space is
between the top of the case and the
upper table (Figure 5.5).
4. Adjust the side belts to fit the width of the case.
5. Place a case—without being folded—
vertically in the proper orientation (RH
facing Vacuum Cups) in the powered
hopper and adjust the hopper table to
the upper stopper mechanism or
fingers approximately ¼” of the case
separating plate on the case (Figure
5.6, 5.7, 5.8, 5.12).
6. Move the stopper with the pin to the
center of the slot of the case (Figure
5.9).
7. While CE-12P is ready to operate in manual mode, press the “Function On”
button until vacuum cup mechanism moves forward (Manual function code 03).
Figure 5.4
Figure 5.5
Upper Table
Side Belts