Copyright 2010 International Safety Instruments, Inc.
9
CAUTION:
The Temperature Scale Readout is
an informational tool ONLY. The accuracy of the
temperature readout is subject to many variations
(emissivity, distance, ambient air temperature, etc.)
and should not be used as an absolute.
3.10.3 The Temperature Colorization system is a
non-contact temperature informational feature that
allows firefighters to estimate the surface, air and gas
temperatures in a very high heat environment.
3.10.3.1 The Temperature Colorization system
is a standard feature of the ISI 3500 (may be
ordered without this option).
3.10.3.2 This feature is automatically on and
does not require any directional input or accurate
aiming by the firefighter to operate.
3.10.3.3 All surfaces and gases having a
temperatures greater than 500ºF (260ºC) will be
yellow, 700ºF (371ºC) will be orange, and 900ºF
(482ºC) will be red. As the temperature rises
4.1 Detachable Handle
4.1.1 The detachable handle comes assembled
and ready to install. The assembly consists of the
following components:
Part Description
Part #
Handle
045144
Head
045145
Wrist Strap Assembly
138035
Attachment Plate
045128
Long Handle Screw (1)
030.147.00
Attachment Plate Screws(2) 030095
4.1.2 Attaching the handle:
4.1.2.1 First turn the camera upside down and
take off the battery deflector by removing the 2
screws holding it in place. Place deflector in a
safe storage area. Do not discard.
4.1.2.2 Line up the handle assembly holes with
the deflector screw holes of the camera.
4.1.2.3 Using the battery deflector screws,
securely fasten the handle assembly to the
camera.
WARNING: Never use the camera
without either the battery deflector or the
detachable handle in place,unless using the
ISI EchoSeeker. Failure to do so may cause
battery to become dislodged during use,
should the camera be dropped, hit, slammed,
or banged, thus causing the camera to stop
operating.
4.1.3 The handle may be attached in the opposite
angle of its original configuration. In order to change
between these designated temperature levels,
there will be a gradual change in color from
yellow to orange and then orange to red.
CAUTION:
The Temperature Scale Readout
is an informational tool ONLY. The accuracy of the
temperature readout is subject to many variations
(emissivity, distance, ambient air temperature, etc)
and should not be used as an absolute.
the angle prior to attachment to camera, remove
the attachment plate and reverse its’ direction. Then
follow the attachment instructions (4.1.2) above.
4.1.4 Attaching the handle to the transmitter:
4.1.4.1 Remove the handle attachment plate from
the handle by removing the two screws.
4.1.4.2 Place the attachment slide on the handle
head and secure with the two screws.
4.1.4.3 Turn camera over. Pull down on handle
latch and slide handle into place until securely
locked. NOTE: Handle slides-in in either direction.
4.2 Remote LCD & Extension Pole
4.2.1 The Remote LCD & Extension Pole comes
complete with 1 remote LCD, 1 2-section extension
pole, 1 extension pole deflector, and 1 coiled cable.
4.2.2 Attaching the pole
4.2.2.1 First turn the camera upside down and
take off the battery deflector by removing the 2
screws holding it in place. Place deflector in a
safe storage area. Do not discard.
4.2.2.2 Place the extension pole deflector on the
camera and secure with the 2 screws.
4.2.2.3 Screw the extension pole into the
extension pole deflector until secure. NOTE: Be
sure the locking cap is in place prior to attaching
the pole.
4.2.3 Attaching the cable
4.2.3.1 Plug the small connector of the cable
into the Remote LCD and then take the large
connector and line up the red dot with the
flat section of the second ring of the camera
4.0 OPTIONS AND ACCESSORIES
!
!
!
