Copyright 2010 International Safety Instruments, Inc.
6
3.2 On/Delay Off Button
3.2.1 To turn the camera on, push the on/off button for
about one second then release. The camera will take
less than 3 seconds to provide a thermal image.
3.2.2 To turn the camera off, push and hold the on/off
button for 3 to 5 seconds until the image disappears.
3.3 Electronic Integration Mode
3.3.1 The thermal imaging sensor and electronics are
designed with an automatic gain control to optimize
the image quality in high temperature environments.
When the camera switches to EI Mode and the letters
“EI” appear on the screen.
3.4 Kevlar
®
Sidestraps
3.4.1 The straps are made of kevlar and use velcro
for adherence.
3.4.2 To adjust, simply separate the 2 velcro pieces
and either pull the strap back through the dowel pin
towards the viewing screen to loosen or pull it forward
through the dowel pin towards the optical lens to
tighten. The side straps are field replaceable.
3.4.3 To remove the side straps, release the Velcro by
pulling the inner piece of webbing from the side strap.
3.4.4 Withdraw the webbing from the pin at the rear of
the camera.
3.4.5 Insert a finger, or two, along the side of the
camera to release the front bumper from the two
bumps that hold the pin. Be cautious not to tear the
bumper.
3.4.6 Remove the front bumper from the camera, but
still have the two side straps woven through the slots
of the bumper. Note this configuration and orientation
of the webbing for future installation.
3.4.7 Remove the bumper completely and then
withdraw the side straps from the pin at the front of
the camera.
3.4.8 Installation is the reverse of this procedure.
3.5 Kevlar
®
Neckstrap
3.5.1 Attach the neckstrap by compressing the large
carabineer until the opening is sufficient enough to
be placed totally around the sidestrap. Release the
carabineer to secure. Repeat this procedure for the
other sidestrap. The neckstrap can be worn several
different ways and is up to the user’s discretion.
3.6 Battery Life Indicator
3.6.1 The battery life indicator is a series of LED lights
located on the right side of the camera next to the
screen.
CAUTION:
It is
recommended to have a
full battery indicated before
entering a fire scene.
3.6.2 The LED’s consist of
two green LED, one yellow
LED, and one red LED.
The top green LED will be
lit for 30 to 45 minutes.
The second green LED
and the yellow LED will be
lit for approximately 1.5
hours (or more depending
on the age of the battery
pack). The red LED will be
lit for approximately fifteen
minutes. When the battery
green
red
green
yellow
!
on/off button
