International MX Composites mxNext, Руководство пользователя

Страница: 34 / 40

RIGGING YOUR mxNEXT
HULL AND APPENDAGES
mxNext sailboats are constructed to be as strong as possible, yet lightweight
to meet the performance needs. The hull and deck are built separately each
of them on molds. Layers of resin-infused carbon fiber are laid in a precise
manner to meet the engineering requirements of the design. Sandwiched
between the layers of carbon is a closed cell foam there to provide stiffness
as well as bouyancy in the event the hull is damaged while out sailing. The
molds, with the materials, are then baked in an autoclave for eight hours.
This kind of construction provides the best stiffness and strength-to-weight
ratio and is strong and durable, but it can be damaged more easily than
traditional, heavier, solid laminate.
Keep your boat clean. Rinse off sand, dirt and salt with fresh water. Be sure
to clean the mast well to assure free rotation of the mast. Wash the boat
periodically and remove stains with a soft brush or sponge, fresh water and
soap or detergent. Do not use an abrasive cleanser.
Minor scratches can be removed by careful wet sanding and polishing the area.
Wetsand the surface first with 400-grade sandpaper, then with 800-grade,
then buff and polish the sanded area. Deeper scratches or cracks should be
repaired as soon as possible. The job is simple. If you have some experience
you can do it yourself using a fiberglass repair kit which can be purchased in
most marine stores. Or consult your local mxNext dealer or International MX
Composites representative.
Always dry the boat before storage. Open the transom drain plug and drain
the hull with the bow placed high up to get all the water out. If you store the
boat inside or under a shelter, leave the drain plug and inspection port open
to allow free air circulation. Keep the boat away from direct sunlight. You
may want to invest in a boat cover if your boat will be stored outside for long
periods of time. A good idea is to apply a couple coats of wax to a clean dry
hull. This will reduce sun fade and make later cleaning easier.
The rudder blade and daggerboard are made of carbon and require the
same general care and maintenance as the hull. Fill in dents, gouges and
MX
T NE
mx NEXT - OWNERS MANUAL
mxNEXT - OWNERS MANUAL mxNEXT - OWNERS MANUAL
CARE & MAINTENANCE
34