International MX Composites mxNext, Руководство пользователя

Страница: 23 / 40

RIGGING YOUR mxNEXT
MX
T NE
mxNEXT - OWNERS MANUAL
RIGGING YOUR mxNEXT
Wait until you have launched the boat before installing the centerboard. You
will need to get the boat situated and the boom on the correct side of the
boat before you put in the centerboard. If you try and do this too early you
will end up with the vang getting hung up on the board and causing all kinds
of issues.
CENTERBOARD
As you prepare to set sail make sure that all your lines are free and ready
to run. Have the tiller and mainsheet in hand and climb on board moving
quickly to the middle of the boat. If you have not already done so pull the
line that lowers the rudder and cleat it off. Lower the centerboard and slowly
sheet in the mainsail moving your weight to compensate for any heel.
SETTING SAIL
You can install the rudder before you launch the boat. There is a bungee that
keep the rudder in the up position. Lower the rudder over the pintals on the
back of the boat and make sure that the metal lock clicks into place so that
they rudder does not come out should you capsize. To remove the rudder
push the plate in and lift up the rudder.
RUDDER
RUDDER DOWN CONTROL LINE
KICK-UP RUDDER
RIGGING YOUR mxNEXT
23