International MX Composites mxNext, Руководство пользователя

Страница: 20 / 40

RIGGING YOUR mxNEXT
MAINSHEET
Attach the two upper blocks to the webbing on the boom using the shackle
that comes with the system. Then attach the lower end to a bracket that
is located just in front of the ratchet block and cleat. Finally lead the tail
through the ratchet block and cleat and tie a figure-8 knot in the end.
SPINNAKER
The spinnaker retrieval sock will come installed on the boat when you receive
it. You will need to install the spinnaker and attach the lines. There are three
lines; the tack line, the halyard and the retrieval line.
Attach the tack - The tack line is led forward and comes out of a small hole
on the bow of the boat. Attach it to the tack of the spinnaker.
Attach the sheet - Tie the single continuous spinnaker sheet to the clew of
the sail and then run it aft through the small block located on the side of the
boat amidships. The sheet then is led across the boat to the small block on
the opposite side and then around the front of the mast to the clew.
MX
T NE
mx NEXT - OWNERS MANUAL
mxNEXT - OWNERS MANUAL mxNEXT - OWNERS MANUAL
RIGGING YOUR mxNEXT
20
MAINSHEET RATCHET BLOCK