Intermec SR61, Руководство пользователя

Страница: 51 / 90

Chapter 4 — Configuration Command Reference
SR61 Cordless Scanner User’s Manual 39
SR61 Configuration Commands
This section lists the configuration commands in alphabetical
order and provides a description of each command. To configure
your SR61 using these commands, see the EasySet software.
Administrator Reset Factory Defaults
Causes the SR61 to perform a restart and restores all
configuration commands to their default settings, including the
Bluetooth PIN. When you restore all configuration commands to
their default settings, you need to reestablish Bluetooth
communications.
Aimer Flashing Mode
SR61 x A (area imager) and SR61 x E (near-far range area imager)
only. By default, the SR61 aimer beam flashes repeatedly while
the imager attempts to read a bar code. The aimer beam flashes
on so that you can see where to aim the SR61 and flashes off to
read the bar code (with the least amount of interference from the
light of the aimer beam). You can change this default setting so
that the aimer is always on.
Australian Post
SR61 x A (area imager) and SR61 x E (near-far range area imager)
only. Enables or disables decoding of Australian Post symbology.
Australian Post is a 4-state bar code that allows Australian Post to
sort incoming mail using a bar code. There are three types of bar
codes corresponding to FCC values 11, 59, and 62. BarDIMM
only needs the DPID and Customer information, and
automatically generates all the other information like the FCC or
Reed-Solomon checksum.
Aztec
SR61 x A (area imager) and SR61 x E (near-far range area imager)
only. Enables or disables decoding of Aztec symbology. Aztec is a
2D matrix symbology made up of square modules on a square
grid, with a square bulls eye pattern at their center. Aztec Code
symbols can encode large amounts of data with user-defined
error-correction level.