Intermec SR61, Руководство пользователя

Страница: 39 / 90

Chapter 3 — Troubleshooting and Maintaining the SR61
SR61 Cordless Scanner User’s Manual 27
Tip: Depending on your screen resolution, you may be able
to scan these bar codes displayed on your computer screen
with an SR61
x A, SR61 x V, or SR61 x E.
Problems and Possible Solutions
Some possible solutions recommend scanning the Administrator
Reset Factory Defaults bar code. Please read the following
caution and note about this command.
After you scan the Administrator Reset Factory Defaults bar
code, the SR61 produces a continuous tone while writing to
the non-volatile memory. Do not remove the battery or place
the SR61 in a 1-bay charger until the tone stops. Otherwise,
the firmware memory may be corrupted.
Note: The Administrator Reset Factory Defaults command resets
all parameters. When you scan this bar code, you will lose
Bluetooth communications.
Problem Possible Solution
You cannot establish a
Bluetooth connection (the blue
Intermec Ready-to-Work
indicator is not on). Scan the following bar code to reset the scanner to its default
configuration and try establishing a connection again.
A dministrator Reset F actory D e f au l ts
\60\08\55\22
You misplaced your SR61 and
you need to find it. If your SR61 is within Bluetooth communication range of
your host PC, you can send the Bluetooth Device Page
command from EasySet to locate your SR61. For help, see
“Paging the SR61” on page 29 .
When you pull the trigger, the
Status light flashes red. The battery is low. Charge the battery immediately, and then
try scanning again.
When you pull the trigger, the
red scanner beam does not turn
on. The battery is low. Charge the battery immediately, and then
try scanning again.
The blue Intermec Ready-to-
Work indicator is blinking. The SR61 is trying to establish a Bluetooth connection with
the host computer, or the SR61 is moving out of range of the
host computer.