Intermec PEN*KEY 6100, Руководство программиста

Страница: 84 / 328

SECTION 3 Supporting Windows Applications
3-16 PEN*KEY
R
6100 Computer Programmer’s Reference Guide
Required SYSTEM.INI Entries
SYSTEM.INI:
[boot]
drivers= power irda pen penwindows scanner npcp
[drivers]
power=norwinpm.drv
pen=uclkpen.drv
penwindows=penwin.dll
drivers= tells Windows to load the installable drivers. This list of drivers is the
standard driver list (in the required order). The significant driver here, is
penwindows . This is just a token name for the driver. The actual driver name
is specified in the [drivers] section of the SYSTEM.INI file:
pen=UCLKPEN.DRV tells Windows the actual name of the installable driver
named in the [boot] section of the SYSTEM.INI file.
penwindows= tells Windows the name of the installable PENWIN driver.
Refer to the example in the SYSTEM.INI Configuration Example paragraph or
see the [
Pen Driver
] section in the example SYSTEM.INI file, in Appendix A,
Sample Configuration Files , for further details on how to configure the Windows
Pen driver.
Hardware Interface
These entries, in the SYSTEM.INI file, initialize the hardware interface for the
PEN*KEY 6000 Series Computer.
Unless otherwise specified, any of these entries used should go into the [pen drivĆ
er] section of the SYSTEM.INI file.
Most of these hardware interfaces default to the values needed for the PEN*KEY
6000 Series Computer and should not need to be set. Note the required values".
PortAddr
Valid values: 0 to 1023
Default value: 520
Required value for 6100 Computer: 512
This entry sets the decimal digitizer base I/O port address.
IrqLevel
Valid values: 0 to 15
Default value: 12
Required value for 6100 Computer: 14
This entry sets the decimal IRQ level used by digitizer.
BaseClock
Valid values: 0 = 33 MHz
1 = 2 MHz
2 = 14 MHz
Default value: 0
"
NOTE: This entry sets the base clock value for Gazelle/Logitech digitizer. The only value that is sup-
ported by the PEN*KEY 6000 Series Computer is the default value of 0.
3. Windows
Applications