Intermec JD2010, Краткое руководство пользователя

Страница: 13 / 22

JANUS 2010 Communications Dock Quick Reference Guide
13
Operating the Communications Dock
Once the communications dock is installed and configured, you can use the
dock to do the following:
•
Communicate with the J2010 and other devices connected to the dock.
•
Charge J2010 reader battery packs.
•
Discharge a J2010 battery pack.
In this section, three LED icons that represent the state of each of the battery
LEDs may appear next to the step.
Discharge Charge Ready
off flashing on
Communicating with the JANUS 2010 Reader
To communicate with the reader and any other devices connected to the dock:
1. Insert the J2010 into the reader slot on the dock.
2. Turn the reader on. The Reader LED lights on the dock. If the Reader LED
is not on, make sure the power supply is connected to the dock and
plugged into an AC outlet.
3. Start your program on the reader or host computer. Data can begin
transmitting between the reader and the devices connected to the dock
ports.
The Receive LED lights when the reader is receiving data. The Transmit
LED lights when the reader is transmitting data.
If you cannot communicate with the reader, check the ports you are using on
the dock and make sure the dock is configured correctly to match your
installation. See “Configuring the Communications Dock” earlier in this guide
for more information.
Charging Batteries
There are two ways to charge the J2010 battery packs:
•
Charge the battery pack using the battery slot in the dock.
•
Charge the battery pack that is installed in the reader while the reader is in
the dock.