Intermec JD2010, Краткое руководство пользователя

Страница: 11 / 22

JANUS 2010 Communications Dock Quick Reference Guide
11
2. If the reader is going to communicate with both dock ports, you do not
need to change the configuration on the reader. Move on to “Setting the
DIP Switches” to configure the dock.
If the reader is going to communicate with only one of the dock ports
(network or auxiliary), you must set the SELPORT signal on the J2010. This
signal allows the reader to select and communicate with the correct port on
the dock.
Use the Communications Dock Port configuration parameter to set the
SELPORT signal on the reader. To set the signal, scan one of the following
bar codes:
Network Port Auxiliary Port
*$+IP0* *$+IP1*
*$+IP0* *$+IP1*
Note: Refer to the J2010 User’s Manual for more information on the
Communications Dock Port configuration parameter.
Setting the DIP Switches
Use the “Dock Configuration Table” on the next page and follow these steps to
set the DIP switches on the back panel of the dock:
1. Identify the dock port you are using: Network, Auxiliary, or Both.
2. Identify the communications you are using between the dock port(s) and
the reader. The reader can communicate with the network port, auxiliary
port, or both ports. The two ports on the dock can also be configured to
communicate with the reader and each other.
3. Identify the type of cable interface you are using: RS-232, RS-422, or RS-485.
Note:
You can connect an RS-422 cable to one dock port and an RS-232 cable to
the other dock port. In this case, you must configure the dock to use one of the
RS-232 interface settings.
Example: 1011
1
2
3
4
4. Find the DIP switch settings that match your dock configuration in the
table. Set the DIP switches on the back panel. To set a DIP switch to 0, push
the switch into the down or “off” position. To set a DIP switch to 1, push
the switch into the up or “on” position.