Chapter 2: Installation
TruVision PTZ 36X Camera User Manual
19
Wiring the dome camera
Caution:
During installation carefully pull the cables so as not to damage them.
It is recommended to fasten the cables once they are connected.
To wire the dome camera (connectors described above):
1. Connect the BNC connector of the dome camera to the coaxial video cable of
a monitor or DVR.
BNC connector
Coaxial video cable
2. Connect the Alarm I/O to a dry contact, for example, a PIR detector or an
access control system.
3. Connect the RS-485 serial data connector to the DVR/keypad.
Note:
See “Cable requirements” on page 3 for information about using a RS-
485 cable for the dome camera.
4. Connect the power cable to the power source. As soon as the dome camera
is connected, it is operational.
Note:
The ground wire must be inserted into the center pin of the power
input terminal block.
Mounting the dome camera on a ceiling
The indoor dome camera can be mounted on a solid ceiling using the hard
ceiling mount that is shipped with the dome camera.
Caution:
Complete all installation steps before supplying power to the camera.
Items needed for mounting
A. Indoor dome camera, which is shipped with hard ceiling mount bracket
B. Screws and screw anchors for fixing the ceiling mount to a hard ceiling (not
supplied.)
Tools needed
Drill
Screwdriver
Содержание TruVision PTZ 36X
