12 IFS MCR200-1T-1TW User Guide
Installation
Install Ethernet over VDSL2 Converter
The Ethernet over VDSL2 Converter does not require any software
configuration. Users can immediately use any feature of this product simply
by attached the cables and plug power on. There is some key limitation on
the Ethernet over VDSL2 Converter. Please check the following items:
MCR200-1T-1TW:
The device is used for
Point-to-Point
connection only
(Master device to Slave device) and has equipped with 2 RJ-11 connectors
for VDSL port. One for voice device connection (like telephone) and the other
one for network link connection.
Depending on the quality of telephone line, the maximum distance of one
VDSL segment is 1.6km (6561ft) with AWG 24 telephone wires.
* The MC251-4P/1CXT and MC250-4T/1CXT can utilize standard
telephone (POTS) type cable for transmission of Ethernet/IP data. It is
not designed for transmitting Ethernet data on a PBX system or
public switch telephone network (PSTN).
MCR200-1T-1TW LAN to LAN connection
Two sets of the Ethernet over VDSL2 Converters could be used to link two
local Area networks that are located in different place. Through the normal
telephone line, it could setup a 100/55Mbps asymmetric backbone, but one
Ethernet over VDSL2 Converter must be Master (CO mode) and the other
one is Slave (CPE mode).
