
http://www.tyan.com
33
procedure
1.
2.
3.
ONBO
ARD
Flash Writer Utility (see page 69).
Hardware CMOS & Password Reset
If you have been locked out of your system because you forgot your
password or set the CMOS incorrectly, follow the instructions below.
1. Power off the system
2. Set jumper JP3 to pins 2 and 3 (see previous page for
location of JP3).
3. Wait for 2 seconds, then return jumper JP3 to pins 1 and 2.
4. Power on the system again.
By following this procedure, you will erase your password and reset the
CMOS to the BIOS defaults.
RAM Installation
The Tiger 100 uses a 64-bit data path from memory to CPU and can
accommodate up to 1024MB of SDRAM. The 168-pin DIMMs must
be of the 3.3V, unbuffered variety. The position of the notch in the
DRAM key position will tell you whether or not a DIMM is unbuffered
(see the figure below). All installed memory will be automatically
detected, so there is no need to set any jumpers.
Some details of memory installation:
•
One unbuffered DIMM must be installed for the system to POST.
•
The mainboard supports 8MB, 16MB, 32MB, 64MB, 128MB
SDRAM; and 256MB registered SDRAM DIMM modules.
The table on the following page shows some of the possible memory
configurations.
RFU
Buffered
Unbuffered
168-pin DIMM