I N S T A L L A T I O N M A N U A L
Z O O M E R A N G ™ S L I D E
11
ZOOM-IM Rev. 9/09 (SBK-INSTAL ZOOM)
Fig. 1
Minimum Concrete Pads – Zoomerang™ Slide
(Plan View – NOT to Scale)
Pool Edge
2 concrete pads are needed:
(1) 12” wide x 32” long x 12” deep
(1) 24” wide x 24” long x 12” deep
Center feet on pads
When installing an Inter-Fab Zoomerang™ slide using a paver kit, you must ensure that all standard
installation requirements are met. The slide must be compatible with the type of pool on the intended
installation and all ANSI/NSPI-2003 requirements must be met. Refer to installation manual.
Figure 1 illustrates an example of the minimum concrete pads recommended for the
Zoomerang™ slide. Specific slide position and concrete pad orientations may vary. Make sure
to allow for water stub up location near the ladder section on the Zoomerang™ slide when pouring
the concrete pad for the ladder section.
In order to ensure proper placement, you will need to
set the slide up first to determine where the concrete pillars will be located.
Figure 2 shows a side view illustration of the Zoomerang™ slide foot pedestal and wedge
anchors used in a paver installation. Pavers can be a maximum of 3” thick. Pavers must be
mechanically attached to the concrete pad using a setting material (such as mortar or thinset
for example) that is no thicker than 3/8”.
For the ladder attachment, 1” of each 3/8” x 7” wedge anchor (4 ea.) needs to be exposed
above the final deck surface. The 3/8” wedge anchors must be drilled to a depth of 6” with 1”
of the bolt left remaining above the final deck surface. For the foot pedestal, 1-1/2” of each
3/8” x 7” wedge anchor (3 ea.) needs to be exposed above the final deck surface. The 3/8”
x 7” wedge anchors must be drilled to a depth of 5-1/2” with 1-1/2” of the bolt left remaining
above the final deck surface. The 3/8” x 7” wedge anchors (7 ea.) replace the 3/8” x 2-3/4”
wedge anchors (4) from hardware kit #1 and the 3/8” x 2-3/4” wedge anchors (3) from hardware
kit #2. You will need to factor in the thickness of your paver (3” MAX.) and the thickness of your
setting material (3/8” MAX.) for your individual installation.
You will need a 3/8” masonry bit for the Zoomerang™ slide.
Inter-Fab Inc. will not be responsible for damage to pavers caused by drilling or mechanically
attaching to concrete pad. Refer to paver manufacturer’s specific installation instructions
before beginning.
Fig. 2
Example of Slide Pedestal on Concrete Pad
(Side View)
CONCRETE
12” min.
Layer of setting
material to
secure pavers
to concrete.
PAVERS
3”
max.
Drawing Is
NOT To Scale
HEIGHT OF WEDGE
ANCHOR ABOVE
FINAL DECK
SURFACE
WEDGE
ANCHORS
24” min.
5” min.
from edge
ZOOMERANG PAVER KIT INFO
