I N S T A L L A T I O N M A N U A L
W I L D R I D E ™ S L I D E
8
WRS-IM Rev. 7/08 (SBK-INST WRS)
STEP FOUR:
Attach Deck Anchors to Legs
TIP:
Use the anti-seize (provided) on all bolts to prevent hardware from seizing.
For On Deck Installation
, slip the leg over a deck anchor as shown. (See Fig. 6) Align the
predrilled holes in the leg with the lower hole in the deck anchor using hardware kit SH-106-SS.
In this order take bolt, flat washer, push bolt through the leg and anchor, then add flat washer,
then nut. Repeat this step for all 4 legs and tighten nuts.
TIP:
You can find the SH-106-SS package inside the deck anchor. There is one for each anchor.
Fig. 6
Fig. 7
Fig. 8
Fig. 9
STEP FIVE:
Assemble Steps
TIP:
Use the anti-seize (provided) on all bolts to prevent hardware from seizing.
Align the holes in the step sections, using a vice grip hold the 2 sections together, then using
hardware kit SH-101-SS, in this order, take bolt, flat washer, push bolt through both step
sections, then place flat washer, then nut.
Fully tighten the bolts, but do not over tighten.
STEP SIX:
Stand the Slide Up
Using 2 people to flip the slide over to its upright position. When you flip the slide make
sure you hold the flume.
DO NOT HOLD THE LEGS TO FLIP THE SLIDE OVER.
STEP SEVEN:
Attach the “L” Brackets to Steps
Attach the “L” brackets to the inside bottom of the steps using hardware kit SH-103-SS. (See
Fig. 8) When installed correctly, the brackets should sit flush with the bottom of the step sides.
(See Fig. 9)
STEP EIGHT:
Align Flume Sections
Align the flume sections for a smooth even sliding surface, then tighten all the flume bolts.
Do not over tighten.
