I N S T A L L A T I O N M A N U A L
D U R O - S P R I N G ™
8
DS-IM Rev. 12/09 (BK-DS INSTALL)
Duro-Spring Steel Stand and Duro-Spring Diving Board
INSTALLATION INSTRUCTIONS
Be sure the concrete deck surrounding the anchor jig complies with the minimum dimensions as
shown in Figure A and Table 3 on page 6.
Read and understand the ANSI/NSPI-5 2003 American National Standard for Residential Inground
swimming Pools and Table 1 and Table 2 on page 5 before you install the Duro-Spring Stand and/or
Duro-Spring Jump Board.
The Duro-Spring three-bolt jig should be set in accordance with Table 3 on page 6 with the “RED” capped
bolt closest to the pool. The diving board must be placed on the deep end of the pool on centerline.
The tip of the diving board must be positioned directly over Pt. A as shown on Figure 3 on page 5
and according to the ANSI/NSPI-5 2003 Standard and Inter-Fab’s Residential Pool Minimum
Specifications.
Make sure the jig anchor bolts project out of the concrete deck 1-1/2” with ample concrete depth
below the jig in accordance with Figure A on page 6. Do not install the Duro-Spring Dive system if
the deck does not meet the minimum requirements.
When finishing the deck surface, maintain a level deck where the jig bolts project out so the dive
stand makes uniform contact with the deck surface. Allow the cement to fully cure before bolting
the dive stand to the jig bolts.
Before bolting the dive stand to the jig bolts, chisel away any excess concrete that may have built
up around the jig bolts then remove the protective red and yellow rubber bolt caps.
Place the stand over the three jig bolts and secure according to the Hardware Instructions on page
9. Tighten the Stand Anchor Hex Nuts to 40-45 FT- LBS. Do not over tighten.
Once the Duro-Spring Stand is properly secured to the three jig bolts, then secure the Duro-Spring
Jump Board to the Dive Stand according to the Hardware Instructions on page 9. Tighten the Board
Mounting Hex Nuts to 20-25 FT- LBS. Do not over tighten.
The Diving Board must be installed according the below board leveling instructions:
The top surface of the diving board from the deck end to
the tip end shall be level or have an upward slope of 5/8"
per foot maximum. Elevation difference shall not exceed
3-3/4" (6’ Board) or 5” (8’ Board) from the deck end to
the tip of the board. There shall be no downward slope
towards the water. The slope shall be measured using a
level as shown in the graphic to the left.
ONLY ONE PERSON ON THE DURO-SPRING JUMP BOARD AT A TIME, WITH A
MAXIMUM WEIGHT OF 250 LBS.
