14
2.
BaudRate
Must be 9600; otherwise the Thermal imaging camera cannot be controlled.
3.
ADDRESS
Setup the camera’s address.
Moving cursor to
and pressing
『
SETUP
』
switch to exit the menu. Before exiting the
setup screen, select
『
SAVE
』
to save your settings.
4.4 Change the address of protocol board
Same with the PT system address.
Only reboot the address will be valid after change address.
The address switch is interface J3 on the protocol circuit board (Refer to Fig.10) which installed in
the CCD camera housing (Refer to Pic.1).
Fig.10
