Stereo Line In 1U System Manual
Connecting a Stereo Line In 1U to the ¼” Jacks on a 7U Case
The
Stereo Line In 1U
module ships with a ribbon cable for connecting to a pair of ¼” TRS
audio jacks — either those built-in to the 2nd generation
Audio Jacks Board
installed in
Intellijel
7U cases
; an
Intellijel Palette case,
or those contained within the separately available
Stereo In
Jacks 1U
module
To connect the
Stereo Line In 1U
module to the jacks installed in your 7U case:
1.
Determine whether your case uses a 1st or 2nd generation Audio Jacks Board.
1st generation boards (included with cases built before early 2019) have a single
connector along the bottom. 2nd generation boards have a large shrouded header
flanked by two smaller shrouded headers, flanked by two link connectors.
IMPORTANT: You can only connect the Stereo Line In 1U module to 7U cases with 2nd
generation Audio Jacks Boards. If you have a 1st generation board, you can purchase a
2nd generation board to replace your original Audio Jacks Board.
2.
Connect one end of the supplied ribbon cable
to the keyed 6-pin connector on the
Stereo
Line In 1U
module and the other end to one
of the two keyed 6-pin connectors on the
Audio Jacks Board
.
Audio arriving at the corresponding pair of ¼”
jacks is sent through to the
Stereo Line In 1U
module for patching into your eurorack
system at the correct voltage levels.
Page 8