Installing Your Module
When installing or removing a module, always turn off the
power to the case and disconnect the power cable. Failure
to do so may result in serious injury or equipment damage.
Ensure the 10-pin connector on the power cable is
connected correctly to the module before proceeding. The
red stripe on the cable must line up with the -12V pins on
the module’s power connector. The pins are indicated with
the label -12V, a white stripe next to the connector, the
words “red stripe”, or some combination of those indicators.
Some modules have shrouded headers to prevent
accidental reversal.
Most modules will come with the cable already connected,
but it is good to double check the orientation. Be aware that
some modules may have headers that serve other purposes
so ensure the cable is connected to the right one.
The other end of the cable, with a 16-pin connector,
connects to the power bus board of your Eurorack case.
Ensure the red stripe on the cable lines up with the -12V
pins on the bus board. On Intellijel power supplies the pins
are labelled with the label “-12V” and a thick white stripe,
while others have shrouded headers to prevent accidental
reversal:
If you’re using another manufacturer’s power
supply, check their documentation for instructions.
Before reconnecting power and turning on your
modular system, double check that the ribbon cable
is fully seated on both ends and that all the pins are
correctly aligned. If the pins are misaligned in any
direction or the ribbon is backwards you can cause
damage to your module, power supply, or other
modules.
After you have confirmed all the connections, you
can reconnect the power cable and turn on your modular system. You should immediately check
that all your modules have powered on and are functioning correctly. If you notice any anomalies,
turn your system off right away and check your cabling again for mistakes.
Pedal IO 1U System Manual
