Quadra & Expander Manual
Installing Your Module
When installing or removing a module from your case always turn off the power to the case
and disconnect the power cable. Failure to do so may result in serious injury or equipment
damage.
Ensure the 10-pin connector on the power
cable is connected correctly to the module
before proceeding. The red stripe on the
cable must line up with the -12V pins on
the module’s power connector. The pins
are indicated with the label -12V, a white
stripe next to the connector, the words
“red stripe”, or some combination of those
indicators.
Most modules will come with the cable already connected but it is good to double check the
orientation. Be aware that some modules may have headers that serve other purposes so
ensure the cable is connected to the right one.
The other end of the cable, with a 16-pin
connector, connects to the power bus
board of your Eurorack case. Ensure the
red stripe on the cable lines up with the
-12V pins on the bus board. On Intellijel
power supplies the pins are labelled with
the label “-12V” and a thick white stripe.
If you are using another manufacturer’s
power supply, check their documentation
for instructions.
Page 4
