Pag.6
www.intelligenthanddryers.com
Dryflow® Vapordri Hand Dryer
2- Fix to wall
by means of screws provided. It is essential the device is properly aligned; it is therefore
advisable to use the bubble level included on the support fixed to wall. Installation height must be
as follows:
3- Connect the hand dryer to the power supply.
4- If when you are operating the hand dryer for the first time, you notice that the sensors do not
detect hands properly, it will be necessary to
calibrate sensors again
. This can be done by removing
front cover. To disassemble front cover, remove two screws at the bottom, and slide it vertically
upwards, where you will find main switch of the device. The switch will be set in “ON position”
when the device is delivered.
Screws for wall fixing. It is recommended to use
screws and wall plugs in all 5 fixing holes.
* Z shows required distance from floor to
the centre of hole of the metallic support to
fix hand dryer to wall.
RECOMMENDED MOUNTING HEIGHT
OF HAND DRYER
Z = 90 cm
Z = 85 cm
1 meter
Z
Slide cover
upwards to
remove it
Screws to fix
front cover
Screws to fix
front cover
OFF
ON
