IA-3178-U2i
33
www.intelligent-appliance.com
Specifications are subject to change without notice
32-ch Relay
USB or RS-232 Controlled
!aaE – Set the Relays to their Initial Defined state
Description
This command Set the Relays to their Initial Defined state
Syntax
!aaE<CR>
!
Delimiter character
aa
Hexadecimal address of the device
E
System control command
<CR> Carriage Return - End of command
Response
|E DN<CR> if the command was valid
Example
Command: !
00E
<CR>
Response: |
E DN
<CR>
This command sets the relays state to the one that was last defined by the
“!00Edddddddd<CR>” command.
This command may be used to deactivate all relays as this is usually the
power-up defined state.
This command remind the ^^E command but it refers to a single board.
