IA-3121-E
17
Specifications are subject to change without notice
32-ch Solid-State Relay (SSR) Board,
Ethernet IP Controlled
IA Series-3000 Daisy-Chain
!aa5dd – Set device mode
Description
This command sets the power-up mode and enables/disables error
messages
Syntax
!aa5dd <CR>
!
Delimiter character
aa
Hexadecimal address of the device
5
System Mode command
dd
8 mode control bits (00-FF)
Bit# Function
1
Enable Error Messages
6
Disable Feedback messages on “!AA2” & “!AAM”
Commands if BIT 7 is cleared.
7
Enable BR change
*Other bits are for future use
<CR> Carriage Return - End of command
Response
|dd EE OK<CR> if the command was valid
Example
Command: !00502<CR>
Response: |02 EE OK<CR>
This command will enable the device error messages (error messages are sent
in response to invalid commands) and will disable baud rate by mistake.
