Intelbras IVP 8000 EX, Руководство пользователя

Страница: 8 / 17

8
6. Identifying the best place for installation
The IVP 8000 EX sensor has communication signal level indications with the AMT 8000 center, this will help you choose
the best installation location. Follow the procedure:
1. Once properly registered, take the sensor to the environment you wish to protect;
2. Check the position where the sensor can cover the whole environment, respecting the installation height, according to
the table in item 1.2. Detection range.
3. Once chosen, position the sensor in the exact place where it will be installed and perform a transmission through a
detection or tamper opening;
4. Observe the color that the LED will light up and check in the following table if the sensor can be installed in this location;
LED status Communication level
Green Excellent signal level (Recommended installation location)
Orange Regular signal level Not recommended location for installation (communication failure may occur)
Red No communication (Do not install on site)
Blue Intrusion detection
5. If the signal level is not excellent, reposition the sensor and perform the procedure again.
7. Installation
Once the best installation location has been identified, set the height of the sensor.
We recommend that this sensor be installed at a height of 1.8 m to 2.2 m and positioned so that the intruder performs
movements transverse to the sensor’s detection radius. It is not recommended to install the sensor tilted up or down as this
may impair the functioning of its PET function.
Check that the sensor is firmly fixed and not subject to flicker, in order to avoid unwanted triggering. The Articulated Bra-
cket can be used to ensure greater flexibility to the installation, adapting to most scenarios and installation angles. Follow
all the mounting instructions in the manual for maximum benefit.
7.1. Anti-Sabotage Function
This function consists of monitoring undue changes in the sensor’s installation angle, ensuring that the sensor is not disa-
bled if its installation position is changed, thus making the alarm system even safer.
After registering the sensor in the center unit, press the synchronism key for the sensor to activate the Anti-Sabotage
function. During the first 2 minutes, the sensor will not trigger the tamper in order to adjust the final installation position.
After the initial 2 minutes, the sensor will go into the test mode, where for 15 minutes the sensor will trigger from the
tamper in the zone in which it was registered whenever its position changes, and then automatically restore this trigger.
After the 15 minutes test period, the sensor will trigger the tamper only if there is a change in its installation position, with
any horizontal or vertical inclination, but it will only restore the tamper if the synchronism switch is pressed.