7
4. Sensor opening
To access the 8000 EX IVP board for registering, changing batteries or to unregister it from the center unit, simply remove
the screw from the bottom with the help of a Philips wrench and remove its front cover. This way the board is exposed and
ready to be handled. See the picture:
5. Registering the IVP 8000 EX sensor
To register the IVP 8000 EX sensor code in the AMT 8000 alarm center follow the procedure below:
1. Insert the battery of LITHIUM 3 Vcc - CR 123 A. The sensor will flash the blue LED for a few seconds (stabilization time),
register the code of the IVP 8000 EX sensor in the AMT 8000 alarm center as follows:
Press the synchronization key of the AMT 8000 alarm center (the blue LED will be on) then press the synchronization button of the sensor
observing if the LED located on the front of it will flash green indicating the correct register. If the LED flashes red, the registration has not
been performed and the procedure must be repeated.
Note:
after pressing the synchronization button of the alarm center, the blue LED indicating the center unit will remain
on for approximately 3 minutes after the last registration made, after this time it will turn off automatically and it will not
be possible to make new registrations until the synchronization key is pressed again. If no device is registered, the LED
indicating the center unit will go off automatically after 3 minutes.
The sensors will be addressed according to the sequence performed, Example: The first sensor will be registered in zone 1,
the second sensor in zone 2, the third sensor in zone 3 and so on.
To register other sensors through keyboard commands and more information, please check the complete manual of the
AMT 8000 center.
5.1. Deleting the sensor register
If you want to delete the sensor registration, just press and hold the sensor synchronization key for approximately 10
seconds, watching the LED indicator until it flashes red twice.
Note:
when physically erasing sensors, they must be erased from the control unit’s memory via programming.
Enter
Enter
01 to 64
Zone number
71
+
+
+
Содержание IVP 8000 EX
Страница 1: ...User guide IVP 8000 EX...
