System Overview
Intel
®
Carrier Grade Server TIGPT1U TPS
Revision
1.0
16
o
Support for single-sided or double-sided dual inline memory module (DIMM) double-data
rate (DDR) memory providing up to 4 GB of system memory with four 184-pin DIMM sockets
•
PC3200 (400 MHz): to run 400 MHz memory at full speed requires an Intel
®
Pentium
®
4
Processor with 800 MHz system bus frequency.
•
PC2700 (333 MHz): to run 333 MHz memory at full speed requires an Intel
®
Pentium
®
4
Processor with 533 MHz system bus frequency.
Note:
PC2700 (333 MHZ) memory will run at 320 MHz frequency when using an Intel
®
Pentium
®
4 Processor with 800 MHz system bus frequency.
o
Intel
®
82547EI Platform LAN Connect (PLC) device for 10/100/1000 Mbps Ethernet LAN
connectivity
o
Intel
®
82541EI device for 10/100/1000 Mbps Ethernet LAN connectivity
o
Two independent PCI buses (one 32-bit, 33 MHz, 5 V; one 64-bit, 66 MHz, 3.3 V) with one
PCI connectors and two embedded devices:
•
One PCI-X 64-bit 66-MHz PCI slots
•
Integrated 2D/3D graphics controller: ATI* Rage* XL Video Controller with 8 MB of
SDRAM
•
Single channel, Ultra 320 Small Computer System Interface (SCSI) Controller: Adaptec*
7901*
o
Low Pin Count (LPC) bus segment with one embedded device: Winbond* W83627HF-AW
LPC Bus I/O controller chip providing all PC-compatible I/O (floppy, serial, keyboard and
mouse)
o
Three external USB 2.0 ports on the back panel with an additional internal header, which
provides support for one additional USB port for front panel support (four total USB 2.0
ports)
o
One serial port and one serial port header
o
Two Integrated Drive Electronics (IDE) interfaces with Ultra 33, 66 and 100 Direct Memory
Access (DMA) mode
o
Support for up to six system fans
o
Server System Infrastructure (SSI)-compliant connectors for SSI interface support: front
panel, power connector
o
Intel
®
Server Management 5.8 support via the National Semiconductor* PC87431M*
Baseboard Management Controller (mBMC)
2.5.2
Full-Height, Full-Length PCI Adapter Subsystem
A one-slot PCI adapter assembly that supports one full-height/full-length PCI adapter is installed
in the PCI riser slot located at the left side of the SE7210TP1-E System Baseboard. This PCI
adapter assembly is configured and installed as shown in the following figure. After the PCI
adapter assembly is removed from the system, it is configured with one PCI adapter by plugging
the PCI adapter into the PCI connector on the riser card (either a 3.3 V riser card or a 5 V riser
card) that is part of the PCI adapter assembly. The PCI adapter assembly is then installed into
the system by plugging the riser card into the riser card connector on the SE7210TP1-E System
Baseboard. Finally, the thumb screw located on the back of the server is secured to the PCI
adapter assembly. Refer to the SE7210TP1-E System Baseboard specification for electrical
characteristics for this PCI adapter subsystem. The maximum power supported for PCI
adapters installed in the PCI Adapter subsystem is 25 watts.
