Intel SR2300 - FRONT BEZEL BLK, Технические характеристики продукции

Страница: 17 / 78

SR2300 2U Server Chassis Technical Product Specification Overview
Revision 1.2
Intel Order Number A94546-004
7
The EPS1U 480W supply consists of a single integrated power supply unit. It operates within
the following voltage ranges and is rated as follows:
• 90 - 132VAC
∼
at 50/60 Hertz (Hz); 8.4A maximum
• 180 - 264VAC
∼
at 50/60 Hz; 4.2A maximum
With either power supply configuration, the power supply provides 480 watts of power and is
designed to minimize EMI.
1.7 System Cooling
The chassis includes three 60-mm non-hot-swappable system fans for cooling the processor(s),
hard drives, and add-in cards. A fourth fan may be added in the fan2 position to provide
conditional cooling redundancy for system components. The system fans are mounted in a fan
assembly located in the middle of the chassis to pull cooling air through the chassis. The power
supplies contain a single fan for cooling.
1.8 Chassis Security
To help prevent unauthorized access to the system’s peripherals and control panel, an optional
key-locked front bezel can be used. The chassis also includes a preinstalled intrusion switch
that can be monitored by server management software. When the cover is opened, a switch
located on the front panel board transmits a signal to the Baseboard Management Controller
(BMC) on the server board. Through server management software, the system can be
programmed to respond to an intrusion by powering down or by locking the keyboard. At the
chassis level a variety of security options are provided.
1.9 Rack and Cabinet Mounting Options
The SR2300 chassis was designed to support 19” wide by up to 30” deep server cabinets. The
chassis comes equipped with a relay rack or cabinet mount kit that can be configured to support
front-mount or mid-mount 2-post racks and 4-post cabinets. Intel also provides an optional
sliding rail kit that is used to mount the chassis into a standard (19” by up to 30” deep) EIA-
310D compatible server cabinet.
For mounting in a regular server cabinet, the front mount brackets are attached to the front of
the chassis, and a set of rear support brackets are attached to the back end of the cabinet. This
evenly distributes the server to prevent the mounting rails on the cabinet from bending. Caution
should be used in using the front mount-only option. Even though the rail mount kit hardware
was designed to support the weight of the system, some 2-post relay racks may not, causing
the racks to fail. Only use relay racks that are specifically designed to support the weight and
stresses of a 2-post front-mount only chassis.