Intel Server Board SE7501BR2 Installation and Integration Guide
Cable Routing – Intel SC5200 Server Chassis, Hot-Swap
Redundant Power Version
Route the floppy drive cable and the hot-swap drive
bay ICMB cable between the chassis wall and the hot-
swap fan holder as shown at location A.
Installing the Plastic Air Ducting - Intel SC5200 Server
Chassis, Hot-Swap Redundant Power Version
1.
An air duct covers the processor. Place the tabs on that air duct into the hinge slots on
the plastic fan carrier, and lower the duct into the chassis.
2.
Another air duct covers the PCI slot area of the server board. Place the tabs on that air
duct into the hinge slots on the plastic fan carrier, and lower the duct into the chassis.
Installing the Access Cover
1.
Place the cover so the tabs go into the slots on the
server. The cover should be flush against the chassis.
2.
Slide the cover forward until it stops.
3.
Tighten the two captive screws into the rear of the
chassis.
21
