Intel Server Board SE7501BR2
Installation and Integration Guide
Installing Chassis Standoffs
If your chassis does not have standoffs placed as shown, you
must rearrange them so they match the holes in the server
board. Failure to properly rearrange the metal standoffs may
cause the server board to malfunction and permanently
damage it. Your chassis may be different from the illustration,
but you must still arrange the standoffs properly.
When using an Intel Server Chassis SC5200, positions 1, 4, 6
20, 23, and 26 come preinstalled. You must install sta
in positions 16 and 19. Install standoffs in the eight positions
marked P
regardless of whether one or two processo
will be installed
. Standoffs are included with this chassis.
,
ndoffs
rs
Installing the Rubber Bumper
e
doff
he
Installing the Server Board
2.
ttach the board, with the screws
✏
NOTE
If a single processor is to be installed, also insert screws into the four
Attach the rubber bumper to the chassis. Th
bumper should cover the indicated chassis stan
hole. On the Intel Server Chassis SC5200, the
standoff is marked ‘
S
’. On other chassis, place t
bumper approximately three inches below and to
the left of the standoffs marked P as shown.
1.
Place the board into the chassis,
making sure that the back panel’s
I/O shield opening and chassis
standoffs align correctly.
A
included with your chassis at the
eight locations shown.
standoff locations bordering the CPU2 socket.
10
