Local Control Panel Kit Installation Instructions
12
Local Control Panel Kit Install Guide
Installation Instructions for Intel® Entry Server Chassis
SC5275-E
Note: This section only applies to Local Control Panel kit installations for the Intel® Entry
Server Chassis SC5275-E. If you are installing a Local Control Panel kit into an Intel®
Server Chassis SC5300/SC5400, follow the instructions under
“Installation Instructions
for Intel® Server Chassis SC5300/SC5400” on page 2
. If you are installing a Local
Control Panel kit into an Intel® Entry Server Chassis SC5299-E, follow the instructions
under
“Installation Instructions for Intel® Entry Server Chassis SC5299-E” on page 19
.
Remove Access Cover
When your chassis is upright (in a tower/pedestal position), and you are facing the front of
it, the access cover is on the left side.
To remove the Access Cover:
1. Power the system off and disconnect the power cord.
2. If the shipping screws are installed, remove both shipping screws (see letter “A” in the
following figure).
3. Slide the two thumb latches (see letter “B”) to the OPEN position.
4. Slide the access cover rearward and lift to remove (letter “C”).
Figure 15. Removing Access Cover
B
B
C
A
A
TP00931
