Intel R2000BB series, Быстрая установка руководство пользователя

Страница: 13 / 22

9
General Installation Process
18
Install Intel® Remote Management Module 4 (optional)
A
Locate the RMM4 Lite connector close to the Riser Slot 2, carefully
pickup the Intel
®
RMM4 Lite module, match the alignment pin of the
module and the connector on server board, then press to install.
Installing the Intel® RMM4 Lite
Push out and remove the metal cover on the chassis where the NIC RJ-45
receptacle will align.
A
Position the module over the server board, fit the front of the module into
the back panel slot, then attach the module to the server board connector.
B
Secure the module with the two screws as shown.
C
Installing the Intel® RMM4 NIC
RMM4 Lite
Connector
A
AF005068
Chassis Back
Opening
Filler
A
B
C
Finger Hole
A
B
19
Install Second Power Supply Module (optional)
A
B
Use the 'finger hole' to remove the
filler panel.
Insert the power supply module into the power
supply cage and push all the way until it clicks
into place.
Using the handle, pull the module from the
chassis while pressing the green latch in the
direction shown.
Power Supply Removal
B
A
A
Recessed
Edge
21
Install the Top Cover
A
B
Place the top cover on system and slide towards the front of chassis
until the recessed front edge is fully engaged.
Install the three screws at the front and torque to 7-9in-lbs, then
install the screw at the back and torque to 7-9in-lbs.
20
Install Bezel (optional)
A
B
A
B
Lock the right end of the front bezel to the rack handle.
Push in the left side of the bezel until it clicks into place.
NOTE: Before installing the bezel, you must install the rack handles.