Intel P4304BT series, Быстрая установка руководство пользователя

Страница: 11 / 16

7
Hard Drive Installation
A
B
A
B
Lift the EMI shield.
move EMI shield
outward from the
chassis.
B. Install the Hard Drive C. Install the EMI shield
A B
Secure the HDD on the
HDD carrier tray with
screws.
Pull out the HDD
carrier tray.
C
Insert the HDD carrier
tray into chassis.
A
B
C
CAUTION: HDDs should be placed evenly in the slots, an empty slot
is needed between every two HDDs.
A
B
While pressing the EMI Shield,
slide the EMI Shield downwards
until the latches on the EMI Shield
are engaged with the chassis.
Fit the edges of the EMI Shield
against the sides of the chassis.
B
A
A
A. Remove the EMI
shield
Fixed Hard Drive Installation
Hot-Swap Hard Drive Installation
A
Remove the drive carrier
by pressing the green
button and opening the
lever. Then slide the
carrier out.
B
Remove the four screws
securing the 2.5" HDD
interface bracket and
remove the 2.5" HDD
interface bracket .
C
Install the hard
disk drive using
the same four
screws as shown.
Make sure the
connector end of
the drive matches
the backplane
connector.
D
E
With the lever open, insert
the hard disk drive
assembly into the cage
opening and push until the
locking lever engages.
Push in the lever to
lock it into place.
A
TOP BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
B
E
D
C
3.5´´ HDD
4
4
NOTE: Return to step on page 2 when finish this section.
5
Follow below Instructions for step on page 2 , then return to step on page 2 when finish this section.
4
5